Skip to the content

Air conditioner problems after a power outage: settings or safety?

Sort air conditioner problems after a power outage into changed settings and safety concerns, with a record to fill in and who to call for each.

Last updated

Air conditioner problems after a power outage sort into two groups. One is controls that have changed: a clock, a timer, or a louvre left open. The other is signs of damage: a breaker that trips, a unit that has been flooded, or a damaged cable. The first group is for your manual. The second needs a licensed inspection before the unit runs again.

How to use this guide

  1. Step 1: Sort it

    Find what you have noticed in the table, and see which group it is in.

    Go to Sort it
  2. Step 2: Write it down

    Record the outage, what has changed and what you can see.

    Go to the record
  3. Step 3: Call

    Read the record out, or paste it into your enquiry.

    Call (03) 5153 2650

Is it a changed setting or a safety concern?

The safety rows follow Energy Safe Victoria's advice on power outages (opens in a new tab), storms (opens in a new tab) and floods (opens in a new tab). The rest is how a split system ordinarily behaves when the power comes back. Models differ in the detail, so check the manual for yours.

After the power comes back: what you notice and what to do
What you noticeWhat it meansWhat to do
Lights are dull or flickering, or only part of the house has powerA problem with the supply. Energy Safe Victoria: do not touch the switchboard or anything metal, turn off power points that are easy to reach, and call your electricity distributor immediately.Leave the air conditioner off. Call your electricity distributor.
A tingle or a shock from an appliance or a tapEnergy Safe Victoria: call your electricity company immediately. A licensed electrician must check the property's wiring.Do not touch the unit. Call your distributor, then an electrician.
Damage to a cable, the wiring, the switchboard or the unitEnergy Safe Victoria: do not turn on the power, do not touch the damaged equipment or cable, and call a licensed electrician to make it safe.Keep clear. See the guide to a damaged air conditioner outdoor unit.
Either unit has been under floodwaterEnergy Safe Victoria: an appliance that has been inundated is not plugged in or switched on until a licensed electrician has tested it.Leave it off until it has been tested.
A safety switch or its circuit breaker is offEnergy Safe Victoria: check whether the safety switch has tripped and, if it has, reset it. If it will not reset, call a licensed electrician. Fuses blowing, or circuit breakers and safety switches turning off, are a reason to contact a licensed electrician.If the safety switch has tripped, the advice is to reset it once. If it will not reset or goes off again, leave it off and call.
It stopped when the lights flickered, then started again by itselfNormal. A large swing in voltage makes a unit stop to protect itself, and it restarts by itself after about three minutes.Note the time. Report it if it keeps happening.
It started by itself when the power came backNormal on many units. They restart in the mode they were in before the power went off.Nothing. The manual for your model says whether it does this.
The louvre stayed open after the power went offNormal. The louvre goes back to its proper position the next time the unit runs.Note it. There is no need to run the unit to find out.
It does not start, and its operation light is offOften a switch for the unit is still off, or a timer is holding it off.Look at the clock and timers on the controller. Then see the guide to an air conditioner that will not turn on.
The clock is wrong, or a timer or schedule did not runNormal. A power cut usually cancels a timer and leaves the clock in the unit wrong.Set the clock and the timers again from the controller, as your manual describes.

What usually goes wrong with an air conditioner after a power outage?

Usual causes of trouble after a power outage
CauseWhat is going onWhat it means for you
Nothing: it is waitingA unit waits about three minutes after the power returns before it restarts. On some models it is longer again before air comes out, up to a quarter of an hour.Give it a few minutes, and check the manual for your model before you treat a slow start as a fault.
Lost settingsA power cut usually leaves the clock wrong and cancels timers.Set them again. This is not a fault.
A tripped safety switchEnergy Safe Victoria tells households to check for one when the power is lost.Its advice is to reset it. If it will not reset or trips again, call a licensed electrician.
Damage from the supply itselfVoltage outside the safe limits, a power surge or a brownout (opens in a new tab), can damage the electronics in an air conditioner. Lightning or a tree across the lines can cause it.A unit that shows a code or will not run once the power is steady needs a technician. See the section on claims below.
Storm or flood damage to the unitEnergy Safe Victoria: do not switch on equipment that is damaged or has been inundated.See the guide to a damaged air conditioner outdoor unit.

Are my air conditioner's timers and schedules still set after a power outage?

Often not. A power cut usually cancels a timer that was set and leaves the clock in the unit wrong, so a weekly schedule does not run properly until both are set again. Models differ in what they keep, so check the manual for yours. On the controller, look at:

  • the clock, and whether it shows the right time
  • any on timer, off timer or weekly schedule, and the times it shows
  • the mode and the set temperature, and whether they are what you left
  • a phone app, if you use one, and whether it still shows the unit

If a setting has changed, set it again from the controller, as your manual describes. That is ordinary use of the controls. One thing to know before you set an on timer again: some units start up to an hour before the set time so the room is ready, and using the remote during that early run stops the unit.

When does an air conditioner need a licensed inspection after an outage?

When the outage came with a storm or a flood, treat the air conditioner like any other electrical equipment that may have been damaged. Energy Safe Victoria says:

A safety switch that tripped in the outage is reset once, as Energy Safe Victoria advises. If it will not reset, or it goes off again when the air conditioner runs, leave it off and call. Switching it on a second time to see whether it holds is not a test, and the guide to air conditioner burning smells and tripping breakers explains what to do. Where water has come from the indoor unit and not from the weather, see the guide to a split system leaking water inside.

Nothing on this page can tell you that a unit is safe to run. If you see none of the signs above and the unit works from its controller as it did before, write down anything that has changed since the outage. If you are unsure, leave it off and call.

Can I claim for an air conditioner damaged by a power surge?

Possibly, from your electricity distributor. The Energy and Water Ombudsman Victoria says to contact the distributor in your area and ask for a claim form (opens in a new tab), and that you usually have to prove the loss and show the voltage variation caused it. The Essential Services Commission says you may also be able to claim (opens in a new tab) on your home and contents insurance. What a distributor covers differs, so ask yours. Keep these:

  • The damaged unit or part. Distributors ask you to hold onto the damaged item while a claim is assessed.
  • A written statement of what failed and why. Distributors ask for one from the repairer. Ask for it when you book the inspection.
  • Photos, and proof of what the unit cost. The Essential Services Commission lists technical reports, photos and receipts as proof.
  • The date and time of the outage, from the record below.

What can I do before the next storm or outage?

  • When lightning threatens, switch the unit off, then switch off its circuit breaker if that is dry and within easy reach. A strike nearby can damage the electronics of a unit that is left connected.
  • When the power goes off, Energy Safe Victoria says to turn appliances off and unplug them (opens in a new tab) at the power point, which helps prevent damage from a surge when the power returns. A wired-in air conditioner has no plug: its isolating switch or its circuit breaker does that job, if it is dry and within easy reach.
  • For the house as a whole, Energy Safe Victoria describes surge diverters (opens in a new tab), which protect a property from voltage surges such as a lightning strike. Fitting one is a job for a licensed electrician.

Record for an air conditioner after a power outage

Air conditioner record after a power outage

Fill this in from what you have seen, then copy it or print it. Do not switch anything on to fill in a blank.

Your answers stay on this open page. They are not saved or sent. Copy or print them before you leave.

Your system

Type of system

The outage

What caused it, if you know
Lights were dull or flickering at any point
Floodwater reached either unit or the switchboard

The air conditioner now

Its circuit breaker or safety switch
The clock on the controller shows the right time
Timers and schedules are as you left them
Louvre on the indoor unit

History

What will a technician do?

When we come out to a unit that has not been right since an outage, we usually:

  • read any fault code the unit stored when the power came back
  • test the power supply to the unit and the electrical parts that start and run it
  • look for signs of heat or water damage
  • tell you what failed and whether the outage is the likely cause

The Australian Refrigeration Council says servicing and repairs of a home air conditioner need a full refrigeration and air conditioning licence (opens in a new tab). Work on the house wiring or the switchboard is for a licensed electrician.

How urgent is it?

Wait first: a unit that is only restarting needs minutes, not a visit. A changed clock or timer is not urgent. A switch that will not stay on, a burning smell, or water or damage from the storm is: leave the unit off and call straight away.

Who to call after a power outage

Who to call, by where the problem is
The problem is withWho to call
The supply to the house: dull or flickering lights, part of the house without power, a tingle or a shockYour electricity distributor. Energy Safe Victoria lists the distributors' phone numbers on its power outages and energy safety (opens in a new tab) page.
The house wiring or the switchboard: a switch that will not stay on, water in the property, damage you can seeA licensed electrician.
The air conditioner: it will not run as it did, it shows a light or a code, or it was damaged or floodedABL or your installer. Say that it started with an outage, and whether an electrician has been.

ABL repairs and services air conditioners for homes and businesses in Bairnsdale and East Gippsland. Our air conditioning repairs page explains how to book. Have your outage record in front of you when you call.

Sources (15)

Want a technician to look at it?

Call ABL or send an enquiry. Have your notes ready: the brand, the model and what the unit is doing.

Filled in the record? Copy or print it first: it is not sent with a call or an enquiry.