Skip to the content

Air conditioner rattling and vibration noise: a record for your technician

What causes an air conditioner to rattle or vibrate, which noises mean stop, what you can safely check, and a sound log for your technician.

Last updated

An air conditioner rattle or vibration usually means something has worked loose, the filters are dirty or badly seated, or a fan is worn. Record where the noise comes from, what it sounds like, the mode the unit is in and when it happens. That log lets a technician start on the right part.

How to use this guide

  1. Step 1: Compare

    See which sounds are normal, then check your own manual.

    Go to Normal sounds
  2. Step 2: Log the sound

    Where, what kind, which mode and when. A phone recording helps.

    Go to the record
  3. Step 3: Call

    Read the log out, or paste it into your enquiry.

    Call (03) 5153 2650

What causes an air conditioner to rattle or vibrate?

Noise usually builds up over time as parts loosen, airflow changes or components wear. The usual causes of a rattle or a vibration:

Usual causes of a rattle or vibration
Possible causeWho deals with it
Screws, panels or brackets worked loose by vibrationA technician.
Dirty filters, or filters not seated properly after cleaningYou, the way your manual shows.
A worn fan motor, or a fan that has shifted or is out of balanceA technician.
A part that has come loose inside a unitA technician.
A poorly fitted grilleA technician or the installer.
Debris in or around the outdoor unitYou, for leaves and sticks around it. A technician, for anything inside it.
On a ducted system, ductwork that is poorly supported or sharply bentThe installer.

A rattle usually means something has come loose. The sound does not tell you what, which is why the log matters.

Which air conditioner noises mean stop?

How urgent a noise is
What you hearWhat to do
Screeching, hissing, banging or grindingSwitch the air conditioner off and call. Banging points to a part that has come loose in the compressor or the fan, and a sharp, steady hiss can be a refrigerant leak.
Any abnormal noise from the indoor unitStop using it and call.
A rattle or buzz from the outdoor unit or a duct that is getting louderBook a visit. A noise caught early helps prevent a bigger problem later. From the indoor unit, the row above applies.
A soft whistleAir is having trouble getting through. See that the filters are fitted properly. If it stays or is loud, turn the unit off and call.
A sound on the normal list that the unit has made all along and that has not changedNothing, if it matches the list in your manual.

Which air conditioner noises are normal?

Every air conditioner makes some noise. These sounds can be part of normal running on a split system. Check the manual for your model for its own list.

Sounds that can be normal on a split system
SoundWhat can make it
ClickingA valve or an electrical part switching. A single click as the unit starts or stops is common.
BuzzingThe flap moving.
Rattling or creaking at start or stopThe flap finding its position as the unit starts up or stops.
BubblingOutside air entering the drain hose, when the room is closed up and an exhaust fan is running, or when strong winds are blowing.
Water flowing while heatingThe outdoor unit defrosting.

The sound on its own does not tell you which part is making it. A sound on the list that is new, or has become louder, longer or different from how it used to be, is a changed noise. So is clicking that repeats while the unit runs, or a buzz that keeps going and gets louder. Log it.

What can I safely check myself?

With the unit off, an owner can check:

  • The filters: clean, and clicked back into place the way your manual shows. A unit that only sounds as if it is working harder may have dirty filters.
  • Around the outdoor unit: keep grass and plants clear of it and brush away leaves and cobwebs. Look for anything leaning on it or stacked against it.
  • On a ducted system: vents that are blocked or partly closed can whistle, so see that each one in use is open and clear.

Is an air conditioner clicking or gurgling sound a fault?

Not necessarily. A single click as the unit starts or stops is common: it can be a valve or an electrical part switching. Clicking that repeats while the unit runs is different, and can point to an electrical or control problem. Bubbling can be outside air entering the drain hose, when the room is closed up and an exhaust fan is running or when strong winds are blowing. A valve can be fitted to the drain hose to stop that, which is a job for the installer.

Try opening a window or the room vents, or turning the exhaust fan off, to see whether the bubbling improves. If it does not, the cause is likely to be something else. Note what you tried and whether it was windy. A click or a gurgle that is new, louder or longer than it used to be goes in the log.

What about a whistle from a ducted grille?

A whistle at a ceiling grille is something to report, not something to fix by changing the grille. Write down:

  • which room and which grille
  • the fan speed, and which zones were on and off at the time
  • whether it started after a change, such as a service, a new zone setting or work in the roof space
  • whether it comes and goes or stays for as long as the fan runs

Do not tape, block or re-aim a grille to stop it, and do not adjust anything in the ceiling. For a room that is also not cooling, see the guide to one zone of a ducted air conditioning system not cooling.

Sound log for your technician

A short recording on your phone, made from where you normally hear the noise, is worth more than a description. Say on the recording which unit you are near.

Air conditioner sound log

Fill in what you can, then copy it or print it.

Your answers stay on this open page. They are not saved or sent. Copy or print them before you leave.

Your system

Type of system

The sound

Where it comes from
What it is like
Recording made on a phone

When it happens

Mode on the controller
Fan setting
Timing
Windows shut and an exhaust fan running
It is getting louder

Conditions and history

What should I leave alone?

Leave the brackets, the mounting, the panels, the fan and the ducts to the technician. Do not tighten, wedge or pad anything to quieten it, and do not run the unit to find the noise once you have logged it.

What will a technician usually do?

With your log and a recording, we can go to the likely part first. A visit usually covers:

  • the fixings: screws, panels, brackets and the mounting of both units
  • the fans and their motors, and anything that has come loose inside
  • the filters and the airflow, and on a ducted system the grilles and how the ducts are supported
  • the motors, the electrical connections, the refrigerant charge and the other internal parts

What a visit costs depends on what is found: the distance travelled, the parts and the time on site all add to it.

What if the noise is bothering a neighbour?

Under Victoria's residential noise rules (opens in a new tab), as at November 2026, air conditioner noise that a neighbour can hear indoors is unreasonable during prohibited times at night and early in the morning, and councils handle reports: the guide to choosing an outdoor AC location gives the times.

A technician can tell you whether a fault is making the unit louder than it should be. A service visit does not decide whether a noise meets those rules.

Who to call

We repair and service air conditioners for homes and businesses in Bairnsdale and East Gippsland. Our air conditioning repairs page explains how to book.