Skip to the content

Electrical requirements in an air conditioning quote: what to have ready

What electrical work a new air conditioner needs, who may do it in Victoria, when a switchboard needs upgrading, and what to record for an accurate quote.

Last updated

A new air conditioner usually needs three things from your wiring: its own circuit from the switchboard, safety switch protection on that circuit, and an isolating switch beside the outdoor unit. Whether your switchboard and your power supply can take that is for a licensed electrician to assess. It is also the part of a quote most often left vague, so this guide shows what to have ready and what to ask.

How to use this guide

  1. Step 1: See what the work involves

    The circuit, the switches and the supply, and why each one moves the price.

    Go to The electrical work
  2. Step 2: Fill in the information pack

    What you can note and photograph for the electrician.

    Go to the record
  3. Step 3: Send it with your enquiry

    We look at the power supply at the site assessment, before we quote.

    Call (03) 5153 2650

What electrical work does a new air conditioner need?

The electrical side of an air conditioner installation
PartWhat it isWhat it means for the quote
A dedicated circuitA cable from the switchboard to the outdoor unit that serves the air conditioner and nothing else, with its own circuit breaker.The further the unit is from the switchboard, and the harder the route between them, the more this part costs.
Safety switch protectionA safety switch watches the current in a circuit and cuts the power in a fraction of a second if it detects a fault that could harm someone.It is part of a new circuit. An older board may have none on its other circuits, which is worth knowing but is a separate job.
An isolating switchA switch beside the outdoor unit that cuts its power, so the unit can be serviced safely.A small item, and it should be named in the quote.
Room at the switchboardA place for the new circuit breaker, in a board that is in sound condition.A full, old or damaged board may need work before a circuit can be added.
Enough supplyThe cable and the main switch that feed the house have to carry the extra load.A large system on a small supply can mean an upgrade, which involves the electricity distributor as well.

The bigger the system, the heavier the circuit. As a guide, a small split system of about 2.5 kW usually goes on a 10 to 16 amp circuit breaker, one of about 5 kW on 16 to 25 amps and one of about 7 kW on 20 to 32 amps, each with heavier cable than the last. The nameplate and the installation manual for the model set the exact requirement.

The maker's instructions carry weight here. Energy Safe Victoria tells electricians (opens in a new tab) that if the manufacturer's specifications require an air conditioner to be on a dedicated circuit, or protected by a safety switch, they must be followed. It lists a missing label on the new circuit breaker among the common defects in split system installations, so look for that label when the job is done.

Who does the electrical work?

A licensed electrician, working for a registered electrical contractor. Energy Safe Victoria (opens in a new tab) says anyone planning electrical installation work must engage a registered electrical contractor, and that doing your own electrical work is illegal and can be deadly.

An air conditioning installer is not automatically an electrician. An Energy Safe Victoria fact sheet (opens in a new tab) says the person who installs an air conditioner must either hold an electrician's licence or engage a registered electrical contractor for the electrical work. There is one narrower licence: a restricted electrical licence for refrigeration and air conditioning lets its holder disconnect an old system and connect a new one of the same power and current in the same place, with no change to the cables. It does not cover a new circuit.

  • Ask each company that quotes who does its electrical work, and under which registered electrical contractor.
  • Ask to see the electrician's licence on the day. Energy Safe Victoria's advice is to ask whenever a tradesperson does electrical work for you.
  • Ask who assesses the switchboard and the supply, and whether that happens before the price is fixed.

What can you note and photograph safely?

A few notes and photos let an electrician judge the job before the visit, and they make a quote by phone or email far more reliable.

What to record for the electrician
What to recordHow to get it
Where the switchboard isWhich wall of the house, inside or out, and roughly how many steps it is from where the outdoor unit would go.
What the switchboard looks likeA photo of the meter box or cupboard closed, and one with its outer door open. Open nothing behind that door: on an older board the panel the switches sit on can swing as well, with live wiring behind it. Stand back and photograph it as it is.
Switches or old fusesWhether you see rows of switches, or older fuse holders that pull out. Look only.
A safety switchA safety switch has a test button and is sometimes labelled. Note whether you can see one. If you are not sure, write that.
The age of the house and its wiringWhen the house was built, and when it was last rewired if you know.
Other big electrical loadsAn electric oven or cooktop, electric hot water, a car charger, a pool pump, a workshop, solar panels or a battery.
Any system being replacedIts brand and model from the label on the unit, and whether there is a switch on the wall beside the outdoor unit.

Age matters because wiring wears. Energy Safe Victoria (opens in a new tab) says the wiring of a house built more than 30 years ago should be checked by a registered electrical contractor or a licensed electrical inspector, and that old wiring can be unable to cope with the demands of modern electrical equipment. An air conditioner is one of the larger loads a house carries.

When does a switchboard need upgrading?

Many installations need no more than a new circuit. An electrician is likely to recommend work on the board itself when:

  • the board still has old pull-out fuses in place of circuit breakers
  • there is no space left for another circuit breaker
  • the board, or the wiring behind it, is in poor condition
  • the main switch or the cable feeding the house is too small for the added load

A board upgrade changes the timing as well as the price. Adding a circuit for an air conditioner is what Energy Safe Victoria (opens in a new tab) calls non-prescribed work: it is turned on when the electrician finishes. Work on the main switchboard, the meter box or the cable that feeds the house is prescribed work. That has to be inspected by an independent licensed electrical inspector, whom the electrical contractor arranges, and it cannot be turned on until it has been inspected.

If the supply itself is too small, the upgrade goes through the electricity distributor, the company that owns the poles and wires in your area. AusNet (opens in a new tab), for one, asks for the existing and the proposed load and the type of supply, and tells customers to speak to their electrician about what the property needs. The cost and the timing are the distributor's, not the installer's. On a rural property, ask the electrician what the line to the house can carry before you settle on a large system.

So settle the board early. Where an upgrade is needed it can be done ahead of time, as its own job, and the air conditioner installed once it has passed inspection.

How do I stop electrical work becoming an unpriced extra?

Ask for the electrical work as its own lines in the quote. A price that says "standard electrical included" tells you little until you know what standard means.

Electrical lines to look for in a quote
Line in the quoteAsk
New dedicated circuitIs it included? Up to what distance from the switchboard, and by what route?
Safety switch and circuit breakerAre both supplied and fitted as part of the price?
Isolating switch at the outdoor unitIs it included, and where will it go?
Switchboard workHas anyone looked at the board? If it needs work, what will that cost, and who decides?
SupplyHas the supply to the house been allowed for? Who deals with the distributor if it has to be upgraded?
Reusing an old circuitFor a replacement, will the old circuit be reused, and who confirms it suits the new unit?
Certificate of Electrical SafetyWho issues it, and when will you get your copy?

If a company cannot price the electrical work until an electrician has seen the board, that is an honest answer. Ask for the assessment first and a fixed price after it. The guide to comparing quotes sets two quotes side by side, line by line, and the guide to standard and non-standard installation covers what else a standard price leaves out.

What paperwork follows the electrical work?

A Certificate of Electrical Safety (opens in a new tab) is required for all electrical installation work in Victoria. For an air conditioner circuit you get your copy within 30 days. The guide to commissioning and handover lists every document to expect, and what to do if one does not arrive.

Electrical information pack for your quote

Fill in what you can see from where you stand, and leave the rest blank. Send your photos with it.

Electrical information pack

Fill in what you can, then paste it into an enquiry with your photos, or read it out when you call.

Your answers stay on this open page. They are not saved or sent. Copy or print them before you leave.

The house

The switchboard

What you can see in it
A safety switch with a test button
Photos taken with the outer door closed and open
Any sign of scorching, damage or damp

What the house runs

The air conditioning

A switch on the wall beside the old outdoor unit

For the quote

Dedicated circuit included
Isolating switch included
Switchboard assessed

Other questions about the electrical work

Does every air conditioner need its own circuit?

Nearly every fixed one does. Air conditioners generally need a dedicated circuit from the switchboard, and where the maker's instructions call for one, the electrician has to follow them. The manual for the model settles it.

Will a replacement air conditioner need new wiring?

Often not, when the new unit goes in the same place and draws no more than the old one. The existing circuit and its safety switch still have to be assessed against the current rules and the new unit's requirements before they are reused.

Will the power be off on installation day?

For part of it. The electrician turns the power off to work at the switchboard. The guide to preparing your home covers what to plan around.

Can I run the cable or fit the switch myself to save money?

No. All of it is electrical installation work. Energy Safe Victoria (opens in a new tab) says unqualified electrical work is illegal, including small jobs.

Sources (17)

Want the electrical work priced properly?

Send an enquiry with your information pack and photos, or call ABL and talk it through.

Filled in the record? Copy or print it first: it is not sent with a call or an enquiry.