Skip to the content

Replacing an old window air conditioner: options for an older house

Your options when an old window or wall air conditioner fails, who removes it and closes the opening, and a checklist that keeps each trade's part apart.

Last updated

In most homes, an old window or wall air conditioner is best replaced with a split system: it is quieter, it uses less power, and the window works as a window again. That makes it three jobs, not one. The old unit comes out, with its refrigerant recovered by a licensed technician. The opening it leaves is closed and weatherproofed. And the split system goes in, with its own power circuit. Plan all three together, so the hole in the wall does not become nobody's job.

How to use this guide

  1. Step 1: Choose the option

    A split system, or another window unit.

    Go to Split or window unit
  2. Step 2: Split up the work

    Removal, the opening, the power and the new system.

    Go to Who does what
  3. Step 3: Fill in the checklist

    Photos, positions and who does each part.

    Go to the record

A split system or another window unit?

A window or wall unit holds everything in one box that sits in the window or in a sleeve through the wall, and smaller ones plug into an ordinary power point. That makes it simple to fit, but it is noisier and less efficient than a split system, blocks the window, and usually lasts 5 to 10 years against 10 to 15 for a split.

When a split system is the better choice, and when another window unit is
Your situationThe better choice
You own the home and want quieter, cheaper-to-run coolingA split system.
You want the window back for light and fresh airA split system, with the opening restored.
You want heating from it as wellA reverse-cycle split system.
You rentAsk the rental provider first. If they will not agree to a split, another window unit in the same opening is the smaller change.
There is nowhere outside for an outdoor unit, or no route for the pipesAnother window or wall unit, which needs no outdoor unit of its own.
The house is under a heritage overlay and the outside cannot easily changeAsk the council first. A like-for-like unit in the same opening may be the simpler path.

As at November 2026, our general guide is $2,000 to $4,000 for a basic home split system, installed. Your quote is the price. Removing the old unit and closing the opening are separate lines, so ask for each to be priced on its own. If you choose another window unit, compare the cooling stars, and see the guide to cooling-only or reverse-cycle air conditioning: many window units only cool.

Who does each part of the job?

Replacing a window unit with a split system, part by part
PartWhat happensWho does it
The old unitTaken out by the technician, who recovers its refrigerant before it is scrapped and labels the unit as emptied.A technician with a refrigerant handling licence. The Australian Refrigeration Council (opens in a new tab) says decommissioning equipment that still holds refrigerant needs a licence, and Look for the tick (opens in a new tab) says the refrigerant has to be recovered before a unit goes to the tip.
The openingClosed to match the wall, or fitted with glass or a sash, then flashed, sealed against rain and draughts, and finished inside and out.A glazier for glass, a carpenter or builder for a frame or cladding, a bricklayer for brick, and a painter. Agree who does each.
The powerA split system needs its own circuit from the switchboard. The old power point stays, or is changed if it no longer suits.A licensed electrician, who assesses the switchboard and issues a Certificate of Electrical Safety (opens in a new tab). See the guide to electrical requirements in an air conditioning quote.
The split systemIndoor unit, outdoor unit, pipes, cable and drain, then commissioning and handover, with a plumbing compliance certificate (opens in a new tab) where the work is $750 or more.A licensed air conditioning technician.

We install the split system. Ask whether a quote also covers taking the old unit away and closing the opening, or whether you arrange those yourself. The guide to removing and disposing of an old air conditioner covers the removal and what records to ask for.

What does closing the opening involve in an older house?

Photograph the opening inside and outside before anyone starts, with something in the frame for scale. The photos show the trades what they are matching, and settle what the wall looked like.

  • Building permit. As at November 2026, Schedule 3 of Victoria's Building Regulations (opens in a new tab) exempts some repairs and alterations from a building permit, on conditions. One is that the work does not affect the structure, such as a lintel or a stud carrying a load. Ask a builder or building surveyor whether closing your opening meets them.
  • Heritage overlay. The Victorian Government's planning guide (opens in a new tab) says a property under a heritage overlay will generally need a planning permit from the council for exterior alterations. Ask the council before the opening is closed or a new outdoor unit goes on a wall that faces the street.
  • Asbestos. A home built or renovated before 1990 likely contains asbestos, Asbestos in Victoria (opens in a new tab) says, and older fibro walls and eaves are common places for it. Have the wall around the opening checked before it is cut or drilled. See the guide to installation and asbestos.

Where will the split system go?

A split system needs new positions, because its indoor unit does not go in the old opening. Mark these on a sketch of the room and the outside wall:

  • the wall for the indoor unit, usually a longer wall of the room and not directly above a window
  • the spot for the outdoor unit, close enough to keep the pipe run short, with air around it and room to service it
  • the route for the pipes and cable through the wall, and where the drain water goes
  • how someone will reach the filters inside and the outdoor unit outside in years to come

The guides to planning the condensate drain and choosing an outdoor unit location go further, and our split system installation page covers where units go.

What if you rent the house?

Renters need the rental provider's written agreement before a split system goes in, because it changes the wall, and the owners corporation's (opens in a new tab) too, if there is one. As at November 2026, Consumer Affairs Victoria (opens in a new tab) says a rental provider cannot refuse some changes without a good reason, including those needed so the renter is not too hot or cold, or to reduce energy bills. The provider can ask for the work to be done by a suitably qualified person. At the end of the agreement the renter restores the property or pays the reasonable cost of restoring it, unless an exception applies.

Rental providers: as at November 2026, Victoria's cooling standard (opens in a new tab) asks for an energy efficient fixed cooler in the main living area at a new rental agreement from 1 March 2027 and in all rentals from 1 July 2030, with exemptions including where installing one is unreasonable, and a window unit there that fails beyond repair is replaced with one that meets it: see the guide to rental heating and cooling standards in Victoria. Check the cooling stars before choosing another window unit.

Window unit replacement checklist

Window or wall unit replacement checklist

Fill this in from what you can see, then copy or print it and send it with your quote request, with your photos of the opening.

Your answers stay on this open page. They are not saved or sent. Copy or print them before you leave.

The old unit

It sits in
It plugs into
It still works

The opening

Photos taken inside and outside, with something for scale
The wall is
Built or renovated before 1990
What should fill the opening
Heritage overlay, or an owners corporation

The new split system

Who does each part

Removal and refrigerant recovery
Closing, sealing and painting the opening
New circuit and electrical assessment

Other questions about replacing a window unit

Can I take the window unit out myself?

Leave it to the technician. The refrigerant has to be recovered by a licensed technician before the unit is scrapped, and the unit is heavy and fixed in the opening.

Is my old window unit now illegal?

No. Since 1 July 2024, new window and wall units holding refrigerant with a high global warming potential cannot be imported or made in Australia. The Australian Refrigeration Council (opens in a new tab) says existing equipment is not affected. Replacing it is your choice.

Can the split system run on the old power point?

Usually not. A split system needs its own circuit, and running one is a licensed electrician's work.

Who to call

We install split systems for homes in Bairnsdale and East Gippsland, including in older homes. Our split system installation page explains how to ask for a quote. Send your checklist and photos with it.

Sources (19)

Replacing a window unit?

Send your checklist and photos of the opening with a quote request.

Filled in the record? Copy or print it first: it is not sent with a call or an enquiry.