Skip to the content

Can a split system replace your living-room gas heater?

Whether a reverse-cycle split can take over from a gas wall heater, who disconnects the gas, what it costs to run, and a brief to send with your quote.

Last updated

Usually, yes. A reverse-cycle split system sized for the living area can do the heating a gas wall heater does, and cool the room in summer as well. Settle three things first: whether it will warm the rooms the gas heater warms now, who disconnects the heater and makes the gas safe, and what happens to your gas bill once it goes. If you own your home, Victoria does not require you to replace a working gas heater, so the choice is yours.

How to use this guide

  1. Step 1: Map the warm rooms

    The room the heater warms, and the rooms around it.

    Go to Heating the same space
  2. Step 2: Sort out the trades

    The gas, the flue, the power and the new system.

    Go to Who does what
  3. Step 3: Fill in the brief

    Send it with your quote request.

    Go to the record

When is a split system the better choice, and when keep the gas heater?

Replacing a gas wall heater with a split system, case by case
Your situationWhat usually makes sense
The heater is old, or has not been serviced for yearsHave it serviced now and consider replacing it, as Energy Safe Victoria (opens in a new tab) advises. A split system is one way, with a gasfitter to make the gas safe.
You want the same room cooled in summerA reverse-cycle split system does both.
You plan to move the house off gasA split system, as the first step of the plan.
The heater also warms the hall and bedrooms through open doorsA split for the living area, plus heating for the rooms it will not reach. See the guide to single, multi-split or ducted layouts.
You rent the home out and the heater has failed beyond repairFrom 1 March 2027 it is replaced with an electric heater. A reverse-cycle split can meet the standard, as the rental rules below explain.
The heater works, is serviced and you are happy with itKeeping it is your choice. A split can still go in for cooling, and the heater can stay as well.

Will a split system heat the space the gas heater heats?

A gas wall heater is often bigger than its room needs, so with the doors open it warms the rooms around it. A split is sized for the room it is in. Before you replace the heater, walk the house on a winter evening and note which rooms the heater keeps warm. If the bedrooms or the hall rely on it, a split in the living area alone may leave them cooler than you are used to.

  • Size it for heating. The unit is chosen for the living area's heating on a cold morning, not for summer cooling. The label (opens in a new tab) gives two heating capacities, one at 7°C outside and one at 2°C. Compare the 2°C figure, and ask what the unit gives on a colder morning than that. The guide to rated capacity and output in very cold weather goes further.
  • Where it goes. A gas wall heater usually sits low on a wall. A floor console can often go in much the same spot, and a wall-mounted unit goes high. The guide to a floor console or a wall-mounted unit compares the two.
  • What changes on a cold day. In heating, the outdoor unit clears frost from its coil now and then, and the indoor fan slows or stops while it does. That is normal: see the guide to outdoor frost and defrost.

Who does each part of the job?

Replacing a gas wall heater, part by part
PartWhat happensWho does it
The gas heaterTurned off, disconnected, and its gas pipe sealed or capped. The heater comes out, or is left in place and made unusable.A licensed gasfitter. Under Victoria's Plumbing Regulations (opens in a new tab), disconnecting and decommissioning a gas appliance is gasfitting work, and Energy Safe Victoria (opens in a new tab) says to use a licensed gasfitter for any work involving gas, including disconnecting an appliance.
The flueAn open-flued heater's (opens in a new tab) flue runs up through the ceiling and roof. A room-sealed heater's flue usually goes out through the wall. It is taken out or sealed off, and the roof or wall is made weathertight.The flue, and any roof sheeting and flashing the work needs, are the gasfitter's. Ask who closes the wall. Older flues can contain asbestos: see the guide to installation and asbestos.
Where the heater stoodThe wall or floor patched and painted, with the capped gas point left tidy.Whoever the quote names. Agree it before the work starts.
The power for the split systemA circuit to the new system, and a Certificate of Electrical Safety (opens in a new tab) for it.A licensed electrician. See the guide to electrical requirements in an air conditioning quote.
The split systemIndoor and outdoor units, pipes and drain, commissioned and handed over, with a plumbing compliance certificate (opens in a new tab) where the work is $750 or more.A licensed air conditioning technician.
The gas meter, if no gas appliance is leftDisconnected for now, or removed for good.You apply through your gas retailer, and the gas distributor does the work.

We install the split system. The gas work belongs to a licensed gasfitter, so ask whether a quote includes it or whether you arrange it yourself. A coordinated quote names each part and who does it, states the heating capacity proposed for the living area and why, says where each unit goes, and lists the making good. Ask the gasfitter whether the work needs a compliance certificate, and keep what you are given with the house papers.

Do you have to replace a gas heater?

If you own your home, no. As at November 2026, the Victorian Government (opens in a new tab) says there is no requirement to replace existing gas space heating or gas cooktops, and that existing gas appliances can continue to be used, maintained and repaired as usual. The rule that changes is for hot water: from 1 March 2027, under the Building and Plumbing Amendment Regulations 2025 (opens in a new tab), a mains gas water heater in an existing house or apartment cannot be replaced with another mains gas water heater, with listed exemptions. From 1 January 2027, new homes cannot be connected to gas, except in specific circumstances.

If you rent the home out, as at November 2026, from 1 March 2027 a fixed heater in the main living area that fails and cannot be repaired is replaced with an energy efficient electric one under Victoria's heating standard (opens in a new tab), such as a non-ducted air conditioner or heat pump with a 2 star or above heating rating for the property's climate area, with exemptions: see the guide to rental heating and cooling standards in Victoria.

If the heater stays, keep it serviced. Energy Safe Victoria (opens in a new tab) recommends that all gas heaters are serviced at least every two years by a qualified gasfitter, including a test for carbon monoxide.

Will it cost less to run than gas?

For the heating itself, usually yes. How much depends on your two tariffs, the two appliances and how you heat, so work it out from your own bills. A modern gas heater turns up to about nine-tenths of its gas into heat. A reverse-cycle unit gives three to five units of heat for each unit of electricity. Gas and electricity are priced differently, so compare dollars, not efficiency.

A comparison for your house

  1. Step 1: Read your gas bills

    A bill shows your average daily use and the same period last year. Winter use above summer use is a rough guide to what the heater uses.

  2. Step 2: Price the split system

    Multiply the energy use on its label by your electricity tariff, or follow the running cost guide.

  3. Step 3: Count the supply charge

    Gas has its own daily supply charge, which stops only when the house leaves the gas network.

The Zoned Energy Rating Label (opens in a new tab) gives the yearly energy use, and the guide to working out running costs from the label has the method and a worksheet.

Fitting it into an all-electric plan

Heating is a good first step, because a split system can replace the heater on its own timetable. A dual-fuel home pays two service charges (opens in a new tab), one for electricity and one for gas, so the gas charge ends only when the house is disconnected from gas, which makes sense once the last gas appliance has gone. Have the switchboard's capacity checked before the first step, and again as each appliance moves to electricity: the guide to electrical requirements in an air conditioning quote covers what to note. A staged plan usually runs like this:

  1. Heating and cooling, with a split system for the living area and others for the rooms that need them.
  2. Hot water, at the end of the gas water heater's life, under the rules above.
  3. Cooking, with an electric or induction cooktop when the gas one is due.
  4. The gas meter, once nothing uses gas.

To leave the gas network, you apply through your gas retailer, who passes it to the gas distributor, the company that runs the network. In Bairnsdale that is Australian Gas Networks. As at November 2026, the Victorian Government's fact sheet (opens in a new tab) says the choice is yours. The main two are abolishment, which removes the meter and cuts the service pipe from the street for good, and disconnection, which locks and plugs the meter so the connection can be used again later. Once you are disconnected, the daily supply charge stops.

As at November 2026, from 1 January 2027 regulation 45C of the Plumbing Regulations, added by the Building and Plumbing Amendment Regulations 2025 (opens in a new tab), bars plumbing work that installs or connects reticulated (mains) gas to an existing building that does not have a reticulated gas connection, with two listed exceptions. Treat abolishing the gas connection as permanent, and check with the gas distributor before you go ahead.

In Lakes Entrance and Orbost, the town gas came from a compressed natural gas network that Solstice Energy is closing. Under the key dates it published (opens in a new tab), customers in both towns had until 19 July 2026 to switch to bottled LPG or to electricity, and gas supply ends after that date. A heater converted to bottled LPG can stay, and a reverse-cycle split can replace it later.

Is there a discount for replacing a gas heater?

In Victoria, the Victorian Energy Upgrades (opens in a new tab) program offers a discount on an approved high-efficiency reverse-cycle air conditioner, and the amount depends on what it replaces, gas heating included. It goes through an accredited provider, or an installer working with one, and the program recommends contacting a provider before you buy, because discounts are typically not applied afterwards. The accredited provider confirms whether a discount applies and how much. That is as at November 2026.

Under the program's activity guide (opens in a new tab), a gas heater replaced this way is decommissioned by a registered or licensed gasfitter, its gas pipe is sealed or capped, photos record it, and the compliance certificate describes the work. The guide to rebates in an air conditioning quote has the questions to ask.

Gas heater replacement brief

Living-room gas heater replacement brief

Fill in what you can see and know, then copy or print it and send it with your quote request. Leave the heater as it is: there is no need to open it or move it.

Your answers stay on this open page. They are not saved or sent. Copy or print them before you leave.

The gas heater

Its flue goes
Gas supply

The space it heats

Ceiling

The new system

Cooling wanted in summer too
Plan to leave the gas network

Who does what

Gasfitter for the disconnection and flue
Making good the wall, floor or roof
Electrician for the new circuit
Victorian Energy Upgrades discount wanted

Other questions about replacing a gas heater

Can I keep the gas heater as well as the split system?

Yes. Keep it serviced.

What if the heater runs on bottled LPG?

A licensed gasfitter still disconnects it and makes the gas safe. The Victorian Government (opens in a new tab) says the use of LPG for households is unchanged by its gas rules.

Should I choose cooling only, since I mainly want summer comfort?

Not if the split system is replacing the heater. See the guide to cooling-only or reverse-cycle air conditioning.

Who to call

We install reverse-cycle split systems for homes in Bairnsdale and East Gippsland. Our split system installation page explains how to ask for a quote. Send your brief with it, and say who is doing the gas work.

Sources (28)

Replacing a gas heater?

Send your replacement brief with a quote request, and say who is doing the gas work.

Filled in the record? Copy or print it first: it is not sent with a call or an enquiry.