Air conditioning an old brick or weatherboard house: what to check first
How brick and weatherboard walls behave, which upgrades to do first, where pipes can run, and a brief to fill in before an older home is quoted.
Last updated
An old brick house can be air conditioned well, and so can a weatherboard one, but the house decides how. What the walls, floors and ceilings are made of sets how much heating and cooling it needs and how it holds a temperature. The same things decide where the pipes and the drain can go. Find out what you have, do the simple building upgrades first where you can, and have the system sized for the house as it will be. Asbestos and heritage controls are separate questions, and each is settled before a hole is drilled.
How to use this guide
Step 1: Know the house
Its walls, floors and ceilings, and how each one behaves.
Go to Brick or weatherboardStep 3: Fill in the brief
The fabric, the routes and the openings, ready for a quote.
Go to the record
Does an old brick house behave differently from a weatherboard one?
Age is a poor guide on its own. An old house that has had its ceiling insulated and its draughts sealed can need less heating and cooling than a newer one that has had neither. What matters is what the house is made of and what has been done to it since.
Uninsulated walls keep out heat about as poorly whatever they are made of. A typical uninsulated weatherboard wall rates about R0.48, brick veneer about R0.56, cavity brick about R0.69, and solid brick with no cavity about R0.3 to R0.4. Filling the cavity of a double brick wall takes it to around R2.0. The real difference between an uninsulated brick wall and a weatherboard one is how fast each takes up heat and gives it back.
| Wall | How it behaves | What it means for the system |
|---|---|---|
| Solid or double brick | Heavy, so it takes up heat slowly and gives it back slowly. After a run of hot days the walls hold heat and release it into the evening and the night. In winter an uninsulated brick house is slow to warm. | Expect the system to run longer and more evenly, and to keep working after sunset in a heatwave. A heavy house responds slowly to heating. Once it is well insulated and sealed, it is usually more comfortable held at a steady temperature than switched on and off. |
| Brick veneer | A timber frame with a brick skin outside it. The bricks sit outside the frame, so they store little useful heat for the rooms, and in summer they reach their hottest in the late afternoon and radiate into the evening. | Behaves much like a framed house with a hot outer skin. Ask whether the wall cavity has insulation: it may have gone in when the house was built, or since. |
| Weatherboard | Light, so it heats and cools quickly. It responds fast to the sun, to a cold change and to the air conditioner. | The rooms come to temperature quickly, and lose it quickly when the system stops. |
Three more things in an older house change the job. A high ceiling adds volume, and the size of the unit has to allow for it. An open fireplace with no damper lets heated and cooled air go up the chimney, so it needs closing off when not in use. And a room with no wall or ceiling insulation needs more capacity than an insulated room of the same size.
A house on stumps has timber floors over an open space underneath. That space can carry pipes, and its floor can be insulated from below like a ceiling. Note whether you can get under the house.
Should you upgrade the house or the air conditioning first?
The house first, where you can. Every bit of heat you keep out or keep in is capacity the air conditioner does not have to supply, and that can mean a smaller system that costs less to buy and to run. The Victorian Energy Upgrades (opens in a new tab) program offers discounts on ceiling insulation, weather sealing and window glazing as well as on heating and cooling. An accredited provider confirms what applies to your home. That is as at November 2026.
| Step | What it involves | Why it comes here |
|---|---|---|
| 1. Find out what you have | Whether the ceiling has insulation and how much, whether the walls do, where the draughts come in, and what the windows are. | You cannot size a system, or choose upgrades, without it. |
| 2. Ceiling insulation and draught sealing | Insulating the ceiling, sealing gaps around doors and windows, and closing off unused fireplaces and old vents. | Usually the simplest gains. In an existing home, have a licensed electrician check the wiring and fittings before insulation goes in. |
| 3. Shading and window coverings | Awnings or other outside shading on the sunny side, and heavy curtains or blinds. | Outside shading keeps more heat out than inside blinds, and both cut the load on the system. |
| 4. Walls and windows, when the chance comes | Insulating walls while they are reclad or relined, and better glazing. | Wall insulation is hard to add to a finished wall, so it usually waits for renovation work. |
| 5. Size and choose the system | A heat load assessment of each room, for the house as it will be. | A system sized before the upgrades can end up larger than the house needs after them. |
You may not be able to do all of it first. Then tell the installer which upgrades are coming and roughly when, and ask how the recommended size changes with and without them. A system that is too large costs more to buy and wastes energy, and one that is too small runs flat out. The guide to sizing a home air conditioner explains how a size is worked out, and the guide to an oversized air conditioner lists the signs of one.
If ducts or a ducted unit are planned for the roof space, plan them with any ceiling insulation, so that one job does not undo the other. Older wiring is a separate check: the guide to the electrical work in a quote covers the switchboard and the circuit.
Where can the pipes and the drain go in an older house?
A split system needs a route for two pipes, a cable and a drain from the indoor unit to the outdoor unit. A ducted system needs room for a unit and ducts, usually in the roof space and sometimes under the floor. In an older house the walls and floors decide which routes are open.
| Route | In an older house | What to note |
|---|---|---|
| Straight through an outside wall | The simplest route. Solid brick is thick masonry, which a standard installation price may not allow for. In a weatherboard wall the hole passes through the cladding and the lining, between the studs. Either way the hole is sealed against the weather. | Which wall, what it is made of, and what is on the other side. |
| Under a timber floor | A house on stumps can carry pipes or ducts under the floor to another wall, if there is enough height to work. | Whether you can get under the house, and roughly how much clearance there is. |
| Through the roof space | Pipes or ducts can cross the roof space to reach an inside room or another side of the house. | Where the ceiling hatch is, and whether the roof is low. A shallow roof space has its own guide: AC options when ceiling space is tight. |
| Down the outside of the house | Pipes run along the wall under a cover to reach the outdoor unit. | Where the run would be seen, especially from the street. |
Then list the openings the house already has. Each one may be reused, and each one is also a place where heated or cooled air can leak out:
- an old window or wall air conditioner, and the hole it sits in. See the guide to replacing a window unit.
- ceiling outlets and ducts from an evaporative cooler. See the guide to replacing evaporative cooling.
- wall vents, unused fireplaces and chimneys
- flues and holes left by old gas or electric heaters
Room boundaries matter as much as walls. Many older houses have rooms joined by wide doorways, arches or a long hall. Rooms that are open to each other act as one space for heating and cooling, so note which doors stay open and which close. That decides whether one unit can serve two rooms or each needs its own.
Last, mark on a sketch where each new hole would go: through which wall, at what height, and what the outside cover would run past. That sketch is what the asbestos and heritage questions below are asked against.
What about asbestos, lead paint and heritage controls?
Each of these has its own answer and its own people, and each is settled before work starts. Asbestos in Victoria (opens in a new tab) says a home built or renovated before 1990 likely contains asbestos, and to check before any work, even drilling into a wall. Looks are not reliable. The guide to asbestos and air conditioning installation in an older home covers who identifies it, what the installer must do, and how it fits into the quote and the timeline.
Paint is the other question in an older house. The Better Health Channel (opens in a new tab) says lead paint was used in many Australian homes before 1970, that homes built more recently may also have paint containing lead, and that renovation work can raise dust or chips of it. Its advice is to seek professional advice if you are unsure. Tell the installer if the walls being drilled carry old paint.
Heritage controls apply to some properties, and they can decide where an outdoor unit goes. Under the Heritage Overlay (opens in a new tab) in the East Gippsland Planning Scheme, a permit is required for works including domestic services normal to a dwelling if the services are visible from a street (other than a lane) or public park, and to externally alter a building. A place on the Victorian Heritage Register is subject to the Heritage Act 2017, and the overlay itself asks for no permit to develop it. Ask the council which applies to your property. That is as at November 2026.
To check, East Gippsland Shire's myLot planning enquiry tool (opens in a new tab) gives a preliminary guide to whether a project needs a planning permit. The council says the result is not a planning decision, so confirm it in writing with the council. In other shires, ask your own council. The permit trigger for services turns on what can be seen from a street or a public park, so where the outdoor unit and the pipe covers go matters. Settle the question with the council before the quote is fixed.
Older home installation brief
Fill in what you know and leave the rest. Send it with your enquiry, with photos of each wall where a unit might go and of the outside where the outdoor unit could stand. Our split system installation page explains how to ask for a quote.
Other questions about air conditioning an older home
Is a split system or a ducted system better for an old house?
It depends on the rooms and the roof space more than the age. Split systems need the least building work, and suit a house where a few rooms are used most. Ducted needs room for a unit and ducts in the roof space or under the floor, and suits a house where most rooms are used together. The guide to choosing a room-control layout compares single splits, multi-splits and ducted, and the guide to bulkhead or ducted covers concealed units.
Should I insulate the walls before I install air conditioning?
Do the ceiling and the draughts first, because they are the easier jobs. Wall insulation is hard to add to a finished wall, so it usually waits until the walls are reclad or relined. If that is years away, size the system for the house as it is now and tell the installer about the plan.
Can my old house wiring take an air conditioner?
That is for a licensed electrician to say. A split system usually needs its own circuit from the switchboard, and an older switchboard may need work first. The guide to the electrical work in a quote lists what to photograph and ask about.
Will the installation take longer in a brick house?
It can, where the wall is thick masonry or the route is long, because both add work. The guide to non-standard installation explains what moves a job outside a standard price.
Sources (11)
Checked on 20 November 2026
- Your Home (Australian Government): insulation, updated 2026 (opens in a new tab)
- Your Home (Australian Government): thermal mass (opens in a new tab)
- Your Home (Australian Government): heating and cooling, updated 2026 (opens in a new tab)
- AIRAH: residential air conditioning best practice guide (Victoria), second edition 2026 (opens in a new tab)
- Victorian Energy Upgrades: choosing the right reverse cycle air conditioner, updated 29 October 2026 (opens in a new tab)
- Panasonic Australia: air conditioning buyers guide (opens in a new tab)
- Asbestos in Victoria: homeowner or renovator (opens in a new tab)
- Better Health Channel: lead exposure and your health, reviewed 27 July 2026 (opens in a new tab)
- East Gippsland Planning Scheme: clause 43.01, Heritage Overlay (scheme updated 2 November 2026) (opens in a new tab)
- East Gippsland Shire Council: myLot, do I need a planning permit (opens in a new tab)
- ABL Refrigeration: air conditioning services (opens in a new tab) ABL's own page.
Related pages
- Split system installation in Bairnsdale and East Gippsland
What ABL installs, and the quote details to send.
- Asbestos and air conditioning installation in an older home
Who checks for asbestos, and how it fits the quote.
- Sizing a home air conditioner: room boundaries, loads and quote assumptions
How the size is worked out for each room.
Air conditioning an older home?
Send your installation brief with an enquiry, or call ABL to talk it through. We look at the house before we quote.
Filled in the record? Copy or print it first: it is not sent with a call or an enquiry.
