Moving a split system air conditioner to another room
What moving a split system to another room involves, when a new system is the better buy, and what drives the cost of moving only the outdoor unit.
Last updated
A split system can be moved to another room, but it is a full reinstallation, not a quick swap. A licensed technician recovers the refrigerant, the units come down, new pipes, cable and drain are run to the new spot, and the system is leak tested and commissioned again. A move is usually worth pricing for a newer unit in good order that suits the new room. For an older unit, or one the wrong size for the room, a new system is often the better buy. Check the warranty before you decide.
How to use this guide
Step 2: Weigh it against new
Age, refrigerant, size, warranty and the two prices.
Go to Move or replace
What does moving a split system involve?
The details follow the installation manual for the model, and the stages are much the same for any split system:
| Stage | What happens | Who does it |
|---|---|---|
| 1. Recover the refrigerant | The refrigerant is pumped back into the outdoor unit or recovered, so none escapes. A unit with a leak is handled differently. | A technician with a refrigerant handling licence (opens in a new tab). |
| 2. Disconnect the power | The unit's circuit is disconnected and made safe. | A licensed electrician. Energy Safe Victoria's restricted licence (opens in a new tab) covers only like for like disconnection and reconnection, and new wiring needs a licensed electrician. |
| 3. Take the units down | The indoor unit comes off its bracket and the outdoor unit off its base. Neither is carried by its pipes. | The technician. |
| 4. Make good the old spot | The old wall hole is sealed, the bracket and pipe covers come off, and the wall is patched. | Agree it in the quote. The guide to removing an old air conditioner covers what to ask. |
| 5. Run the new route | New pipes, cable and drain to the new spot, a new base or bracket for the outdoor unit, and a circuit with an isolating switch beside it. | The installer and a licensed electrician. |
| 6. Test and recommission | A leak tightness test, evacuation, the refrigerant adjusted for the new pipe length, and commissioning to the maker's instructions. | The licensed technician. |
| 7. Paperwork | The plumbing and electrical documents for the work done. | The licensed plumber and the licensed electrician. |
The refrigerant handling code of practice (opens in a new tab) requires a leak tightness test after a system is moved. In Victoria, installing, altering, testing and commissioning refrigerated air conditioning equipment is plumbing work under regulation 23 of the Plumbing Regulations (opens in a new tab). A move involves each of those. As at November 2026, a plumbing compliance certificate is required where the plumbing work totals $750 or more, under the Building Act 1993 (opens in a new tab) as the Building and Plumbing Commission (opens in a new tab) explains, and the electrical work needs a Certificate of Electrical Safety (opens in a new tab). You can check a technician's licence at Look for the tick (opens in a new tab).
The new route usually gets new pipe, because the old pipe is cut to the old run. The guide to reusing refrigerant pipes explains when old pipe can serve.
Should you move it or replace it?
A move pays when the unit has plenty of life left and suits the new room. These are the things we weigh:
| What you know | What it points to |
|---|---|
| It is a few years old, runs well and suits the size of the new room | Moving it is worth pricing. |
| It is near the end of its life | A new system. Home systems usually last 15 to 20 years, and parts for older models get harder to find. |
| It runs on R22 | Usually a new system. Existing R22 units are not banned and can still be serviced, but the Australian Refrigeration Council (opens in a new tab) says R22 imports end on 1 January 2030, after which servicing relies on recycled refrigerant, and spare parts may become harder to find. |
| It is too small or too large for the new room | A new system sized for that room, or a move to a room it does suit. |
| It is still under the maker's warranty | Read the warranty first. Several makers' warranties do not cover a unit reinstalled at a location other than the original one. |
| It has had leaks or repeated repairs | A new system. See the guide to repairing or replacing an air conditioner. |
| You still want the old room cooled | Leave it where it is and add a unit in the new room. |
Compare two written prices: the full move, including the work at the old spot, and a new system installed in the new room. As at November 2026, ABL's published guide for a basic home split system is $2,000 to $4,000 installed, and your quote is the price.
As a rule of thumb, if the quote to move the unit comes to more than half the quote for a new system, the new system is usually the better value, because it starts its life and its warranty from the day it goes in.
Will the unit suit the new room?
A unit that was right for one room can be wrong for another. Too small and it works hard and struggles on the hottest and coldest days. Too large and it runs in short bursts. The size depends on:
- the floor area and the ceiling height
- the insulation in the ceiling and walls
- the windows, and which way they face: a large north or west window lets in much more heat
- how the room is used, and whether it opens onto other spaces
The capacity is on the unit's nameplate or in its manual. Set it against a new heat load for the room, not against the room it came from. The guide to sizing a home air conditioner explains why floor area alone does not settle it.
The new spot also needs a route. The outdoor unit has to sit within the model's pipe length and height limits, on a sound base, with somewhere for the drain to go. See the guides to slab or wall bracket and planning the drain. If the house was built or renovated before 1990, read the guide to installation and asbestos before a new hole is drilled.
What drives the cost of moving only the outdoor unit?
Outdoor units get moved for a new deck, an extension, a path or a neighbour. It is a smaller job than moving the whole system, and it is still refrigerant and electrical work. What drives the price:
| Cost driver | Why it matters |
|---|---|
| Whether the pipes reach | If they do not, they are extended with joins, which are best made permanent and kept to as few as possible. |
| Extra refrigerant | Past the length the factory charge allows, measured refrigerant is added for each extra metre. The guide to standard and non-standard installation gives the usual lengths. |
| The model's limits | The new run has to stay within the maximum length and height between the units. |
| The isolating switch and cable | The switch sits beside the outdoor unit, so it moves with it. That is a licensed electrician's work. |
| The new base | A slab, feet or a wall bracket at the new spot. |
| Height and access | A spot that is high, tight or far from the old one adds time and equipment. |
| Recommissioning | The system is tested and commissioned again whatever the distance. |
Each of these depends on the model and the site, which is why a fair price comes after someone has seen both. Think about the neighbours too: as at November 2026, Victoria's residential noise rules (opens in a new tab) set the hours when air conditioner noise heard in another home is unreasonable, and the guide to choosing an outdoor unit location sets them out.
Move or replace comparison sheet
Other questions about moving a split system
Can I take my split system with me when I move house?
It can be removed and reinstalled at the new house, and it is the same work as a move between rooms, with the travel in between. Check the warranty first. The terms say location, so ask the maker in writing whether a new address counts. Allow for making good the wall it leaves behind.
Can I take it down myself and have someone reinstall it?
No. The refrigerant has to be recovered by a licensed technician before the pipes are opened, and the power disconnected by a licensed electrician. A unit taken down any other way can lose its refrigerant and be damaged.
How long does a move take?
As a guide, a standard split system installation takes us 4 to 6 hours, and a move adds the work at the old spot. The quote should say what is done on the day and what, such as patching and painting, comes after.
Who to call
We install split systems for homes in Bairnsdale and East Gippsland. Our split system installation page explains how to ask for a quote for a new system. Send your comparison sheet with it, so the quote can be weighed against the cost of a move.
Sources (23)
- Mitsubishi Electric Australia: installation manual for MSZ-AP25 to AP50 split systems (opens in a new tab) Checked on 20 November 2026.
- Fujitsu General Australia: installation manuals for ASTH and AOTH 07 to 14 KMCD split systems (opens in a new tab) Checked on 20 November 2026.
- Panasonic Australia: installation instructions for CS/CU-Z TKR split systems, 2017 (opens in a new tab) Checked on 20 November 2026.
- Australia and New Zealand refrigerant handling code of practice, part 2, 2025 edition (opens in a new tab) Checked on 20 November 2026.
- Australian Refrigeration Council: frequently asked questions (opens in a new tab) Checked on 20 November 2026.
- Australian Refrigeration Council: Look for the tick (opens in a new tab) Checked on 20 November 2026.
- Energy Safe Victoria: Restricted Electrical Worker's Licence, reviewed 1 July 2026 (opens in a new tab) Checked on 20 November 2026.
- Energy Safe Victoria: Certificate of Electrical Safety (opens in a new tab) Checked on 17 November 2026.
- Plumbing Regulations 2018 (Victoria), version 010 (opens in a new tab) Checked on 20 November 2026.
- Building Act 1993 (Victoria), version of 13 November 2026 (opens in a new tab) Checked on 17 November 2026.
- Building and Plumbing Commission: compliance certificates (opens in a new tab) Checked on 17 November 2026.
- Building and Plumbing Commission: practice note MS 07, split system air conditioning, 29 August 2024 (opens in a new tab) Checked on 19 November 2026.
- Daikin Australia: if I move house, can I take my split system? (opens in a new tab) Checked on 20 November 2026.
- Mitsubishi Electric Australia: air conditioning system warranty, 2025 (opens in a new tab) Checked on 20 November 2026.
- Samsung Electronics Australia: air conditioner warranty, 2024 (opens in a new tab) Checked on 20 November 2026.
- ActronAir: warranty terms and conditions, July 2025 (opens in a new tab) Checked on 20 November 2026.
- Mitsubishi Electric Australia: after sales support (opens in a new tab) Checked on 20 November 2026.
- AIRAH: residential air conditioning best practice guide (Victoria), second edition 2026 (opens in a new tab) Checked on 20 November 2026.
- Solar Victoria: choosing the right reverse-cycle air conditioner system size, updated 15 May 2026 (opens in a new tab) Checked on 20 November 2026.
- Australian Refrigeration Council: fact sheet 26, R22 gas and equipment, July 2026 (opens in a new tab) Checked on 20 November 2026.
- Australian Refrigeration Council: fact sheet 22, HFC gas and equipment, July 2026 (opens in a new tab) Checked on 20 November 2026.
- EPA Victoria: residential noise, updated 4 November 2026 (opens in a new tab) Checked on 20 November 2026.
- ABL Refrigeration: air conditioning services (opens in a new tab) ABL's own page. Checked on 20 November 2026.
Related pages
- Split system installation in Bairnsdale and East Gippsland
How to ask for a quote for a new system.
- Can existing refrigerant pipework be reused?
When old pipe can serve the new spot.
- Repair or replace an air conditioner: how to compare the two quotes
When the unit has a fault as well.
Weighing a move against a new system?
Send the model of the unit you have and a description of the new room when you ask for a quote.
Filled in the record? Copy or print it first: it is not sent with a call or an enquiry.
